Rifle Scopes How Do you Reset Zero Stop On NightForce?

[samnev]

I set the Zero Stop on my NightForce NXS 5.5-22X50 I sebsequently changed loads and need to add a few clocks of down elevation. Before I mess things up has anyone done tha reset. If so would you be kind enough to provide instructions.
TIA.

 

[T2CH]

Re: How Do you Reset Zero Stop On NightForce?

Romove the cap. Then loosen the four screws on the top of the turret. You can see the clutch and the stop looking at the turret from the side. After loosening the 4 screws turn the top piece (the one with the screws in it) counterclockwise so you back it off the zero stop.

Tighten the four scres and replace the cap. Zero the scope. When the scope is zero'd, Remove the cap and set it so it indicates zero. Then dial one Mil (or MOA) down. Remove the cap and set the zero stop at here. Replace the cap so it shows one Mil (or MOA) low. Dial back up to zero and you should be GTG.

 

[KillShot]

Re: How Do you Reset Zero Stop On NightForce?

 

[samnev]

Re: How Do you Reset Zero Stop On NightForce?

I followed the above to set the Zero stop but there was no info on how to reset it once the initial set is done unless i missed somehting.

 

[mjh30]

Re: How Do you Reset Zero Stop On NightForce?

Back off the shoulder stop a little that will give you some slack,

 

[samnev]

Re: How Do you Reset Zero Stop On NightForce?

Any recommendation on how much to back off the shoulder stop?

 

[Trigger Monkey]

Re: How Do you Reset Zero Stop On NightForce?

Give it one revolution, that should free you up plenty and after you get your final zero just bring it back around until it stops.

 

[samnev]

Re: How Do you Reset Zero Stop On NightForce?

Thanks for the info guys.