I have zero’d my day scope with out the thermal. Do do have to adjust thermal or just clip it on, put in clip on mode and go.
Night Vision How to zero Iray RH25 as a clip on with lvpo day scope
- Thread starter LC 6.5 Shooter
- Start date
I just put it in clip on mode and check zero. Usually I'm a little low and have to adjust my zero. I just dial my day scope to the correct POI
When adjusting the x/y in clip on mode does any point of reference pop up to show how much you are adjusting or is it just the x/y values
Just values, I would adjust inside rh25 so you can keep the same zero w or w/o thermal.
yeah I think Ill adjust in the rh25. I like keeping my day scope true when not using the thermal.
So if the poi is an low and right from poa I would adjust y axis value in the negative direction and the x axis value in the positive direction?
Any idea the value of one click/adjustment of the y or x axis value?
I think it's easier to adjust the day scope. Mine is never off far and I just set my turrets to my zero for my day scope and the know when I take it off I just go back to my zero stop
Similar threads
