HRD AX mag spacer kit

[justinmac13]

Does anyone know where I can get one of these kits still, they appear to be out of stock and not really making them anymore.

 

[carbonbased]

Does anyone know where I can get one of these kits still, they appear to be out of stock and not really making them anymore.

They appear to be out of business.

People use this kit, which involves cutting down the stock follower. Not sure if you can buy just the factory 308 follower if you want to switch back. I couldn’t find any, but I didn’t look too hard.

https://patriotvalleyarms.com/6mm-br-6mm-dasher-mag-kit-aw-spacer/

You are probably better off to just buy this dedicated 6br mag that fits AW magwells:

BR/Dasher AW Magazine

DISCLAIMER: PLEASE READ Our Billet AW magazines have a (12) round capacity and cannot be shipped to the following states. Please check out our (10) round compliant version: California, Connecticut, Delaware, Hawaii, Illinois, Maryland, Massachusetts, New York, Rhode Island, Vermont, Washington...

grayopscnc.com

I own both the HRD and Gray Ops and I think the latter is probably better. I didn’t have to tune it for it to work flawlessly in my AT. Haven’t tried it in my AX, however.

 

[anon]

The Gray Ops mags seem to work fine in my AT-X with 6BR, but I don't yet have enough rounds through them yet to have found any problems.

 

[justinmac13]

Perfect. Thank you guys