I recently acquired an IOR QR-TS 3x25. I mounted it on a POF and took it out yesterday to zero at 100 yds.
I maxed out the upward elevation adjustment, yet still hits about 2" low at 100. The windage was fine after an adjustment of R 2.25 moa, but the elevation is as high as it will go.
The scope is commonly used for ar setups, so I found it odd that I'd run into this problem. Can I remedy this or is it a product failure?
I maxed out the upward elevation adjustment, yet still hits about 2" low at 100. The windage was fine after an adjustment of R 2.25 moa, but the elevation is as high as it will go.
The scope is commonly used for ar setups, so I found it odd that I'd run into this problem. Can I remedy this or is it a product failure?
