I bought a Trim-it 2 used off another member some months back but hadn't had the chance to use it until just this week. Trying to set it up I've run into a couple issues I never had using one my friend had in his shop.
I can't seem to back it off enough to trim my brass to the appropriate length (1.91"). Everything I run through it is coming out at 1.905-1.907.
Also, it chews up my brass whenever I run it in my drill vs just by hand. Not sure if the drill might be the issue, but it appears to be wobbling when run at medium speed? The drill is a Dewalt 20v brushless so its not a cheap POS.
Any advice would be appreciated.
I can't seem to back it off enough to trim my brass to the appropriate length (1.91"). Everything I run through it is coming out at 1.905-1.907.
Also, it chews up my brass whenever I run it in my drill vs just by hand. Not sure if the drill might be the issue, but it appears to be wobbling when run at medium speed? The drill is a Dewalt 20v brushless so its not a cheap POS.
Any advice would be appreciated.