Killflash for Minox

1NDY

Private
Minuteman
Sep 2, 2019
33
10
Gentlemen,

I have the Minox ZP5 5-25x56 and want to put a killflash on it. I attempted to contact Minox Europe and their response had nothing to do with what I was asking (language barrier I believe) and have also contacted Tenebraex with no respons....SO.... Has anyone with this scope found a killflash that will fit correctly on it? Has anyone tried the Tenebraex generic 56mm killflash device on theirs. Any input is much appreciated.
 
Gentlemen,

I have the Minox ZP5 5-25x56 and want to put a killflash on it. I attempted to contact Minox Europe and their response had nothing to do with what I was asking (language barrier I believe) and have also contacted Tenebraex with no respons....SO.... Has anyone with this scope found a killflash that will fit correctly on it? Has anyone tried the Tenebraex generic 56mm killflash device on theirs. Any input is much appreciated.
 
  • Like
Reactions: 1NDY
20220515_111922.jpg
 
  • Like
Reactions: Dobermann and 1NDY
Good to know, thanks for that.
The other thing that's worth knowing is that - for their scope covers at least, not sure about killflash units - the Tenebraex is smooth but pliable, while Aadmount stuff is harder and (I think), 3D printed. For scope caps, Tenebraex feel like cheap Tupperware to me, but I haven't seen too many accounts of them failing. Jon's stuff feels more robust, and the stippled finish of the printing makes it a bit easier to grip them. But as they're less pliable, they feel like they could be more brittle ... again, I haven't seen that in practice. But they are loud, and I have one occular cap that quit engaging after only a few weeks. I have no doubt Jon will take care of it, though.

All that to say, I honestly don't know which of the two I like better ... they each have their followers, but I see pros and cons with both.