Rifle Scopes leveling a H34L Aimpoint, no bottom flat red dot

[AnglerDown]

I have an Aimpoint H34L red dot which has a 34 mm round bottom tube. there are no flats on the bottom too use a wedge leveler. there are also no flat surfaces on the top. if I remove the battery compartment lid on the side there is a flat surface.

How can I level this scope? I am trying to use a Spuhr one piece mount .

 

[oldrifleman]

I looked at the directions and the scope and I have come to the conclusion that it does not need to be leveled. The closest I could find is to use a sideways level across the top push buttons.

 

[srt-4_uk]

Gonna make it a bitch to zero if it isn't level.

I'd take off the "turret" caps and put the level across the vertical adjustment screw shroud. Should get you pretty close.

 

[Tictacticaltimmy]

I'm confused... Isnt that a simple 2moa dot? There's nothing to level

 

[oldrifleman]

I think that is the point, but it does confuse the up/down/left/right adjustment structure a bit.

 

[sloporsche]

I spent days leveling this n that had it all perfect ,put it on the kitchen table looking out in the back yard bagged in and the cross hairs were off......loosened the mount screws and turned the scope retightened the screws . tested at the range ....done

 

[oldrifleman]

Wait, the H34L is a 2moa red dot, it has no crosshairs to level.