M1A and Troy MCS 18 inch scout

[fmsniper]

after some bedding I finally got the troy MCS to lock up tight with no zero shift.

I put devcon steel bedding in the area where the stock meets the rear sight area and I drilled and tapped a steel piece that fits in the stripper clip guide, then bolted it to the stock as an extra mounting point , all bolts are red locktite

shoots 1.5 - 1 3/4 with German Military surplus, gun actually shoots tighter as the barrel warms up.
had fun shooting out to 400 Meters on steel all 1st round hits

 

[fmsniper]

Re: M1A and Troy MCS 18 inch scout

scope flat dark earth, was going to do the entire rifle, but may end up selling it if my SCAR 17 comes in

 

[solidarmy]

Re: M1A and Troy MCS 18 inch scout

fmsniper,
How has your patch job held up?
I have a Troy MCS and I believe I am experiencing the same problem. I'm trying to decide to fix it like you did or send it back.

 

[fmsniper]

Re: M1A and Troy MCS 18 inch scout

working good no issues, the glass bedding made a difference

 

[JD42]

Re: M1A and Troy MCS 18 inch scout

Very nice set up!