Manners MCs-TA and Mesa dbm bedded for Curtis Vector

DangerRanger · Jun 13, 2019

Stock invoice should be attached, only imperfection is that the bottom of the forearm where it meets the bottom metal is slightly higher on the left than the right. Like to the tune of 1/32 or 64of an inch or something.

It’s set up with Mesa precision m5 dbm for my vector to run 6.5 prc. Straight jacket did the pillar install and glass bedding and such($275). Nick set it up so the vector bolt just barely grazes the feed lips of my accurate mag, then I polished the feed lips up so it just doesn’t touch with a piece of high grit paper and about 20 seconds.

Barrel channel is inlet for my proof sender 2.5” shank barrel. It should run an m24 steel barrel or less. It’s a great looking stock that gets tons of compliments!

I would like 800 shipped for the stock and bottom metal.

I can also include the accurate wsm mag if you’re building a short mag since it’s already set up for that 3rounder. I’d like 60$ for that so I can turn around and buy another one.