Has anyone else had difficultly installing one of these on the chassis? I'm not sure if this is a manufacturing defect or if I'm just retarded but there is a small lip on the small side of the T-nuts that came with the bridge. So it's a little bit wider than the mlok slot on the chassis and doesn't fit into the slot. I can still thread the screw in partially, but it doesn't get much thread engagement, and the screw isn't seated straight. Theres a lip on all 4 nuts it came with. Shot an email to MDT but wondering if anyone on here has had any experience. Pic attached and this is the bridge I'm talking about:
MDT ACC gen 1 mirage shield/NV bridge question
- Thread starter bllistc
- Start date
The lip is necessary to hold the nuts in place while you slip the mirage cover over top. If they didn't have that, there would be no way to install it.
Fuck me. I was trying to put them in from the inside of the chassis. In my defense it’s been a long day and I just got off work. Thanks man.
