• Frank's Lesson's Contest

    We want to see your skills! Post a video between now and November 1st showing what you've learned from Frank's lessons and 3 people will be selected to win a free shirt. Good luck everyone!

    Create a channel Learn more
  • Having trouble using the site?

    Contact support

Rifle Scopes Mount too close to objective bell?

Z06pilot

Online Training Member
Supporter
Full Member
Minuteman
Jul 30, 2017
179
35
Usa
I just pulled my mark 8 3.5-25 out of a larue mount and installed into a bobro. Everything is level, properly torqued, ring gaps are even side to side. Scope tracked properly, and returned to zero. The only thing i boticed is that on the front ring, there is a .002" greater gap at the front than the rear on both sides, see attached pic. Is this a problem?

I should mention that the level is not touching the ring, but it is hard to tell from the pic
 

Attachments

  • photo69553.jpg
    photo69553.jpg
    94.9 KB · Views: 57
  • photo69554.jpg
    photo69554.jpg
    71.2 KB · Views: 51
Last edited: