my first AR build - 6.5 Grendel

NordicG3K

Private
Full Member
Minuteman
Jan 2, 2009
75
0
Southern Oregon
Well, the wait was longer than expected, the cost was more than anticipated, but it's done! I probably won't get a chance to shoot it until tomorrow though. I've only got a few rounds loaded so it won't be a big deal anyway. Just enough to check for function and see if my load data will work for fireforming purposes. Here's the parts breakdown:

Templar 18" stainless barrel
PWS flash suppressor
Larue gas block
Vltor MUR upper
Vltor CASV handguard/rail system
Noveske N4 lower
DPMS lower parts kit
JP 3.5lb trigger
DPMS charging handle w/ Badger tactical latch
KNS pin set
Magpul MIAD grip
Magpul PRS stock
Larue bipod adapter
Harris bipod
ADM Recon 35mm QD scope mount
IOR 2-12x32 scope
Vltor CASV-FS flip-up front sight
Matech 600m flip-up rear sight
Specter 3-point sling

I've got a Young Manufacturing NM carrier on order, but it'll probably be another few weeks so I cannibalized a Bushmaster carrier from another AR.

This is my first AR build. I was a bit intimidated at first (I am no gunsmith by ANY stretch of the imagination), but I have to say I'm pretty pleased with the outcome (assuming it actually works). It wasn't nearly as difficult as I was anticipating. This definitely fits the "why didn't I do this sooner?" category!

grendel01.jpg


grendel02.jpg


grendel03.jpg


grendel04.jpg


grendel05.jpg


grendel06.jpg


grendel07.jpg


grendel08.jpg