Other than one piece mounts are these made? The SPUHR mount with the Razor sits a bit high on my rifle so I need to lower it. I thought about sending the stock to "stockdoc" here on the hide but I'd rather not alter the stock unless absolutely needed. Plus I have a Triad stock pack on and the straps are not long enough to attach when I raise it up. Another option is to change out the 0 moa base for a 20 moa base in hopes of having more options with 35 mm rings.
-
Having trouble using the site?
Contact support
Need help finding 35mm low rings, with 20 moa built in
- Thread starter Ultraman550
- Start date
What rifle is this on and how far out do you plan to shoot? Reason I ask is that the Razor has a lot of internal elevation and you might not even need a 20 MOA base. With the 125 MOA available in the scope that gives you, theoretically, 62.5 MOA on a flat base.
Hey Rob,
I bought the Razor/SPUHR at Mile High and thought the 1.18 (lowest of the two) would be sufficient but its high. I have a Stiller Tac 30 action, medium palma contour barrel and its all in an HS precision pro 2000 stock. Currently I just hit 765 this past weekend (.308) and I'm trying my best to hit over 1000+. I'm using hand loads of 175 SMK and 178 BTHP and AMAX with a MV of 2700 out of a 26" barrel not including the length of the suppressor. You're right in that I probably don't need the extra 20 moa of elevation so it seems like the best option is to either get lower rings that have 0 moa built in or get a 20 moa base from Stiller and a set of low rings? Also when this barrel is shot out I'll probably change it to a .260, 6.5 or 7mm so I can reach out past 1000+ so the extra 20 moa might come in handy?
I bought the Razor/SPUHR at Mile High and thought the 1.18 (lowest of the two) would be sufficient but its high. I have a Stiller Tac 30 action, medium palma contour barrel and its all in an HS precision pro 2000 stock. Currently I just hit 765 this past weekend (.308) and I'm trying my best to hit over 1000+. I'm using hand loads of 175 SMK and 178 BTHP and AMAX with a MV of 2700 out of a 26" barrel not including the length of the suppressor. You're right in that I probably don't need the extra 20 moa of elevation so it seems like the best option is to either get lower rings that have 0 moa built in or get a 20 moa base from Stiller and a set of low rings? Also when this barrel is shot out I'll probably change it to a .260, 6.5 or 7mm so I can reach out past 1000+ so the extra 20 moa might come in handy?
Last edited:
According to JBM, with those numbers and round you should make 1300 yards with the 62 MOA available on a flat base. That's at 50 degrees at sea level. It's 36.8 MOA to 1000 yards.
So the option of a 20 MOA base is going to be up to you but get a lower set of rings. The Seekins/Vortex .95" height 35mm rings would do the trick. If you have the money you can go with both. You can always sell the Spuhr to finance it.
So the option of a 20 MOA base is going to be up to you but get a lower set of rings. The Seekins/Vortex .95" height 35mm rings would do the trick. If you have the money you can go with both. You can always sell the Spuhr to finance it.
Similar threads
