Hi guys, i jist recently inherited a flock of older NF Scopes. One that really caught my eye was the 2.5x10x24. This is a beautiful scope, my one gripe is its a MOA. Is it worth going in and getting NF to convert it to mils? Thoughts?
NF 2.5x10x24 question
- Thread starter Alaskaman11
- Start date
I have a 2.5-10x32 in MOA/MOA. If you dial for every shot it is a pain in the butt.
My ballistics calculator spits out either one and I have a dope sheet printed. I hold using the reticle and if I need to dial, I do it in 10 MOA increments and add in the reticle as needed.
I asked Nighforce a while ago if they would change the reticle to MIL. They said they could but the knobs would remain MOA. It was $300 to do the change.
My ballistics calculator spits out either one and I have a dope sheet printed. I hold using the reticle and if I need to dial, I do it in 10 MOA increments and add in the reticle as needed.
I asked Nighforce a while ago if they would change the reticle to MIL. They said they could but the knobs would remain MOA. It was $300 to do the change.
I was told that there are hardly any of these 24s out there as most went to LEO or mil. Have you seen any out there?
They are come up for sale a couple times a year. The 1-8 NX8 and the 4-16x42 ATACR have become pretty popular. The cloners like the NXS.
If it has nsw markings it will go for 3+
I had one of those like 7-8 years ago. It was on a clone.
Being moa will limit the interested parties.
If you want mil, I’d look to try and trade a cloner for their late build mil/mil. If you want clone “correct” don’t mess with it if it’s mildot.
These are very capable scopes. For me, Mildot holds are not precise as a MOAR, etc but you can still get the job done, fast.
Mk12 mod0 FTW. Can is available again in its original configuration and it’s a wonderful can, despite being an 20+ year old design.
If you don’t care about 100% clone correct and just want it to look the same, probably one of the most attainable builds with PRI reproducing and all the parts.
These are very capable scopes. For me, Mildot holds are not precise as a MOAR, etc but you can still get the job done, fast.
Mk12 mod0 FTW. Can is available again in its original configuration and it’s a wonderful can, despite being an 20+ year old design.
If you don’t care about 100% clone correct and just want it to look the same, probably one of the most attainable builds with PRI reproducing and all the parts.
Similar threads
