**Edit** I should have stated earlier, but this works during the daylight as a normal bubble level also. The tritium vial has no effect during daylight hours.
I made up a couple nighttime scope bubble levels for a few buddies and I was seeing if there would be any interest here, if so I might start offering them along with the other items I print.
Currently is setup for 30mm tube. It is printed from carbon fiber reinforced nylon materials. There is a tritium vial behind the bubble level that acts as the illuminator. The images attached are somewhat grainy, as it was rather difficult to get an image after dark that focused where I needed it but non the less it shows what's needed.
This is a hinged ring that clamps on the scope tube. There is a pocket that a nut slides into that you can see in the image so the threads and bolt will be stainless. The hinge pin is also stainless. If your current scope setup is in a one piece AR type scope mount there may not be room to slip the bottom half of the ring between the base and bottom of scope tube which would then require the scope to be removed from the rings and bubble installed and remounted. All scopes mounted in "regular" rings should have clearance.
The total price shipped to your door would be around $80, mostly depending on tritium cost. This would be a specific niche. I know there were some similar on the market currently but i couldn't find much with tritium vials as the illuminator. If there are some good ones already out there please feel free to let me know. Thanks.
I made up a couple nighttime scope bubble levels for a few buddies and I was seeing if there would be any interest here, if so I might start offering them along with the other items I print.
Currently is setup for 30mm tube. It is printed from carbon fiber reinforced nylon materials. There is a tritium vial behind the bubble level that acts as the illuminator. The images attached are somewhat grainy, as it was rather difficult to get an image after dark that focused where I needed it but non the less it shows what's needed.
This is a hinged ring that clamps on the scope tube. There is a pocket that a nut slides into that you can see in the image so the threads and bolt will be stainless. The hinge pin is also stainless. If your current scope setup is in a one piece AR type scope mount there may not be room to slip the bottom half of the ring between the base and bottom of scope tube which would then require the scope to be removed from the rings and bubble installed and remounted. All scopes mounted in "regular" rings should have clearance.
The total price shipped to your door would be around $80, mostly depending on tritium cost. This would be a specific niche. I know there were some similar on the market currently but i couldn't find much with tritium vials as the illuminator. If there are some good ones already out there please feel free to let me know. Thanks.
Attachments
Last edited: