Removing the Rem. X-Mark trigger...HELP!

[Remy700ranger14]

Hey ya'll im tryin to remove my X-Mark trigger (the first one) so i can look at doing some bedding, but cant figure out how to access the screws to let it out. It seems like they're covred by the bolt release assembly on one side and the saftey on the other....any info (PICS) would be great, thanks guys.


And YES i did a search but came up with nothin...

 

[armymedic.2]

Re: Removing the Rem. X-Mark trigger...HELP!

not being a jerk here, but if you're looking for screws you have it all wrong my friend.

just take a lot of pics from all angles, then pics at each step so when the bolt release and the springs go all nutzoid on you you have reference. and if you're taking it off......

timney has a nice trigger for it, and they use keeper pins to hold the spings in place, which you then drive out with the real pins as you install. it doesn't get any easier, unless you are swapping a trigger in a weatherby vangaurd where it really is just one screw.


good luck, post in the gunsmith section if you need help.

 

[fiveoshooter]

Re: Removing the Rem. X-Mark trigger...HELP!

Remember to move the safety to the" SAFE" position before removing the rear pin.......

 

[shooter444002]

Re: Removing the Rem. X-Mark trigger...HELP!

Those little keeper pins sure do help!!

 

[Remy700ranger14]

Re: Removing the Rem. X-Mark trigger...HELP!

Awesome guys i thought they might be pins but didnt want to break anything. good stuff, THANKS!