SAC Modular Sizing Die Disassembly Help

[jps24]

Anyone have tips on how to remove the decapping rod from the SAC modular sizing die? Once I unscrew the top cap from the die body I can't seem to figure out how to remove the decapping rod to disassemble the rest of the parts.

 

[simonp]

Good question, tagged for answers.

You removed the retaining spring in the top right?

Still doesn't seem to want to come loose though

 

[jps24]

When I unscrew the top cap, the taper adapter is still snug around the er11 collet and decapping rod. So I can't push the decapping rod out through the top of the top cap, if that makes sense

 

[jps24]

Nevermind. I just had to pry off the taper adapter from the collet and everything came apart easily after that.

 

[Cynical]

Nevermind. I just had to pry off the taper adapter from the collet and everything came apart easily after that.

I was just about to tell you to take a screwdriver and put it between the collet and and cone shaped tapered piece, and just turn the flat head screwdriver to pop that piece off. But you figured it out.

 

[nalye]

Since I had the same problem today here's the official answer from SAC according to their mail:

If you ever get one of our die wrenches, they have a tool built into them to pop that right off. Otherwise, when the taper adaptor is stuck, you can grab the assembly by the pin and whack it against the corner of your loading bench, right at the little gap that between the topcap and taper adaptor.

 

[thegotoguytx]

Thanks Guys, having that same issue this morning....and my comment back to SAC would be "if you make some more of the SAC die wenches I'd be happy to buy one."