I have a pre accu-rigger 30-06 that my son wants to convert it to 7 prc. It's my understanding that to make the conversation I would need a new barrel and bolt face. The issue I'm having is tracking down the bolt face that's needed. Can anyone point me in the right direction? Is this all that's needed or did I miss something/miss understand?
-
Having trouble using the site?
Contact support
Savage 111 conversion from 30-06 to 7 prc
- Thread starter Joey6
- Start date
You’ll want a .540 magnum bolt face for the prc chamberings. No idea on savage bolt head availabilities.
You’ll also need a mag in addition to the bolt head and the barrel.
Have him look up a 280ai which is just a necked down modified 30-06 case and should be a straight barrel only swap with the same .473 bolt face. It’s not going to match the prc for pure volume but it is no slouch either.
You’ll also need a mag in addition to the bolt head and the barrel.
Have him look up a 280ai which is just a necked down modified 30-06 case and should be a straight barrel only swap with the same .473 bolt face. It’s not going to match the prc for pure volume but it is no slouch either.
As mentioned, you’ll probably need a mag follower or mag, the barrel, and bolt head. Here is a link to a bolt head in stock.
www.gunshack.com
Savage LA Bolt Head Push Feed Small Firing Pin Right Hand Magnum
Savage LA Bolt Head Push Feed Small Firing Pin Right Hand Magnum - 103960 - Bolt Heads and Parts - Savage Arms Bolt Head Long Action Savage 110 to 116 Push Feed Small Firing Pin Hole Right Hand 7mm Remington Magnum, 300 Winchester Magnum This is a factory
www.gunshack.com
7 PRC is a magnum cartridge and may not stack/feed properly in a .30-06 magazine.
Similar threads
