Gunsmithing Savage firing pin bushed- By who??

[hafejd30]

Bottom line I have a friend with a Savage. Getting primer flow with Lapua SRP brass. Nothing else for pressure signs and what not

My go to is LRI but don’t think they work on savages. I know you guys are on other forums and could point me in the right direction for this

Who would bush a savage bolt?

 

[loveha]

Why not just buy a new bolt head? Unless it's cheaper to bush it?

 

[hafejd30]

Why not just buy a new bolt head? Unless it's cheaper to bush it?

Who makes them? PTG I see but figured having this one bushed would ensure I wouldn’t run into any fitment issues

This is the worst one I had out of 100. Most were 1/2 this bad. I have a bench source annealer and noticed a decent amount of wobble in some cases. Was noticed at lower charges as well and seems to be a common issue like the AI rifles have.

This is 43.0 grains of H4350 and 143 ELDX. Zero pressure signs besides the cratering that I can tell. Good bolt lift, no ejector marks etc

CCI 450 small rifle magnum primer
Lapua SRP brass
H4350 43 grains

 

[6.5SH]

Bottom line I have a friend with a Savage. Getting primer flow with Lapua SRP brass. Nothing else for pressure signs and what not

My go to is LRI but don’t think they work on savages. I know you guys are on other forums and could point me in the right direction for this

Who would bush a savage bolt?

Gunsmith Work

Savage bolt bushing: 60 Fill the ejector hole in Savage bolt heads: 30 Bolt lift kit installed and tuned up in my shop: 27 Remington 700 or any other one piece bolt, bushing: 90 Shipping is typical…

deshind.com

Several threads on https://forum.accurateshooter.com about his work, is a member there and savageshooters forum.

 

[teele1]

here is who bushed 3 for my F/Class bolts

Grimstod did a fantastic job

You are being redirected...

 

[John Glidewell]

You can contact @carlsbad too, he does them and has great reviews here. I swapped bolt heads and added one of these https://www.midwayusa.com/product/101887670?pid=451940 and cratering is gone.

 

[AllenOne1]

Grimstod he is the guy you are looking for he can also install a bolt lift kit that is top of the line in that area as well.

Benjamin Chappell

Desh Industries LLC. 552 Coolidge St. New Cumberland, PA 17070

 

[hafejd30]

Grimstod he is the guy you are looking for he can also install a bolt lift kit that is top of the line in that area as well.

Benjamin Chappell

Desh Industries LLC. 552 Coolidge St. New Cumberland, PA 17070

Deshind is the website for Grimstod correct? Same guy?

 

[6.5SH]

Deshind is the website for Grimstod correct? Same guy?

Yes

 

[AllenOne1]

Deshind is the website for Grimstod correct? Same guy?

Yes it is

 

[hafejd30]

I directed my friend to him. Thank you!