Scope mounting and zeroes?

[Noles77]

Ok I took a scope off an RPR and swapped in another scope off another setup? Ok now the scope is bottomed out and set at zero(on turrets) but is still shooting like 5 inches high at 100’ and no down vertical adjustment. This scope tracks well and have had no issues in the past with it? So what do I need to change up to get it back to zero at 100 swap out rings maybe?

 

[davsco]

any chance you need to undo the zero stop?

 

[Sogan]

Does one scope have more available mils than the other? do you have a 0moa, 20moa rail or scope mount?

 

[Noles77]

Sorry havnt been on in awhile... the original rifle that the scope was taken off of had 20moa rail installed. The rifle it’s installed on now has a zero MOA rail. As stated I have no more vertical adjustments at 100’ and it shoots high.

 

[wade2big]

You need to adjust your zero stop. Right now it is doing its job.