Hey guys, I was mounting a scope last night with Seekins rings and one of the clamp screws at the base broke off when torquing it down.
I had the wrench set to 55in/lbs. I could tell something wasn’t right because it was turning but not feeling tighter and was taking too long to reach the torque value. Heard a pop and the screw was broken in half.
Has anyone else had this happen? I was really nervous to do the remaining screws but they seemed fine.
I had the wrench set to 55in/lbs. I could tell something wasn’t right because it was turning but not feeling tighter and was taking too long to reach the torque value. Heard a pop and the screw was broken in half.
Has anyone else had this happen? I was really nervous to do the remaining screws but they seemed fine.