Rifle Scopes Signature Zee rings angled inserts

[Low Sioux]

I have a set of Burris rings with 20 min inserts to install. They dont come with instructions. Does anyone know how they install? Do you use the +20 and -20 as a set, or do you use the +20 and a 0 on top as a set? Any help is appreciated. Thanks

 

[powell]

Re: Signature Zee rings angled inserts

Do you want any cant or do you want it flat? You can set them up an way you want.

 

[calling4life]

Re: Signature Zee rings angled inserts

They should come paired up in the package, I assume these are 1" because the 30mm only go up to the 10.

It should be two halves to equal the whole(obvious) a +20 and -20, a +10 and -10, a +5 and -5

You want to keep these halves together, if you want a 20moa adjustment, put the -20 on the bottom of your front ring and the +20 on the top of that ring, then the 0 inserts in the back ring.

If you want 30moa of adjustment, do that same 20 setup in the front, but have the +10 on the bottom in the back with the -10 on the top.

But, again, keep the 5s, 10s, and 20s together as their sets, don't use a 5 top with a 10 bottom...

Put something on the inside of the rings before you put the inserts in, something that will prevent rust, whatever you like to use.

 

[calling4life]

Re: Signature Zee rings angled inserts

And Burris' website has detailed instructions on this, check it out, watch all their videos, read up etc...

Because you can adjust these to keep your guns natural poa centered as well.

 

[Low Sioux]

Re: Signature Zee rings angled inserts

Thats what I figured. Just wanted to be sure. Thanks for the help.