Up for sale is my MPA BA competition chassis. Full length Arca cut, right handed, Castle cut magwell, front Arca spigot. traditional bubble level, and MPA locking washer action screws. Includes barricade stop, extra pic rail segments for both bottom of chassis and for front spigot if needed. Also includes the skid pad shown.
Chassis is factory cerakote black and has seen a fair bit of use, has been my primary match chassis. All works well, just has scrapes and bright spots in the cerakote along the arca rail and bottom of the gun. Perfect plug and play for someone looking to build a match rig. The bright spots you see near the action screws is clear tape holding the action screws in the chassis.
Chassis has been bedded for a Bighorn TL3 short action. Fits like a glove on both my TL3 actions, held zero perfectly. I'm sure you could chip the bedding out and run some other action if you wanted.
$700 shipped SOLD
Chassis is factory cerakote black and has seen a fair bit of use, has been my primary match chassis. All works well, just has scrapes and bright spots in the cerakote along the arca rail and bottom of the gun. Perfect plug and play for someone looking to build a match rig. The bright spots you see near the action screws is clear tape holding the action screws in the chassis.
Chassis has been bedded for a Bighorn TL3 short action. Fits like a glove on both my TL3 actions, held zero perfectly. I'm sure you could chip the bedding out and run some other action if you wanted.
$700 shipped SOLD
Last edited:
