Sold

[Herman1]

Looking for a Neck sizing die and Lapua brass for a 6mm creedmoor.

 

[shakemandril]

I have approximately 240 pieces of 2x Lapua 6.5 brass I would be willing to sell for $125 shipped. Also have a set of Hornady match dies for another $50 if interested. It's a full length sizer but uses neck bushings (269 included) if you're interested. Thanks.

 

[Herman1]

I have approximately 240 pieces of 2x Lapua 6.5 brass I would be willing to sell for $125 shipped. Also have a set of Hornady match dies for another $50 if interested. It's a full length sizer but uses neck bushings (269 included) if you're interested. Thanks.

I m looking for 6 cm brass at this time

 

[shakemandril]

Sorry, I was still under the impression lapua didn't make 6 creed. I had been converting 6.5 to 6mm

 

[Herman1]

Is this brass already converted?

 

[shakemandril]

It’s neck sized to 6mm with the above mentioned die. I didn’t turn any necks, just used them as they were. My barrel is done so I switched to 6XC.

 

[FishDr]

@shakemandril
I’d take these if Herman1 isnt interested.

 

[Herman1]

It’s neck sized to 6mm with the above mentioned die. I didn’t turn any necks, just used them as they were. My barrel is done so I switched to 6XC.

I will take them. Do you use PayPal? 9076324460