Hey guys, question (that I am sure already has an answer to out there somewhere), so I just bought a Supertrickler from a guy on SnipersHide, just the dispensing unit, and a brand new FX120 scale (which isn’t preprogrammed for any dispensing device). The ST had already been updated to the latest firmware, and I have not messed with or changed any of the current settings on it. I got the ST and the scale hooked up and proceeded to follow the ST manual on getting the scale programmed to work with the ST. After doing that and looking like all is good, when I try to then calibrate, through the ST unit, I am getting very different reading on the scale vs the ST. For example, if I place a load on the scale that measures 55gr on the scale, the ST will show a measure of 5500. Also, I am using a 100g weight for calibration. I am sure I’m missing something along the way, but I’ve gone back through several times and can’t figure out what’s causing the disconnect between the devices. Any help would be greatly appreciated!
-Josh
-Josh