SOLD Tikka TAC A1 Chassis and CTR mags

[david walter]

It's definitely used but not abused. Bought from another member, decided to go in a different direction.

MLOK slots have a good amount of wear / marring due to a DIY weight kit that's since been removed.

I'm thinking $600 with the three 308/6.5 Creedmoor/6mm Creedmoor CTR mags shipped sounds fair, or $475 without?

Optic rail and hardware included.

Rail is configured for a T3X, but can be made to work with a T3. Difference is in the hole in the receiver top on a T3X allows included rail recoil pins to work.

 

[bdn6465]

So the recoil pins do not align with the T3 action as is?

 

[david walter]

The recoil pins are on the rail, and the T3 lacks the holes for the pins to fit down into.

The T3X has two additional holes on top of the action to accommodate these pins.

On a T3, you can tap the pins up into the rail, and just use the 4 screws for the rail.

 

[Bevo]

Damn good deal right here. Where were you a couple months ago!?!

 

[david walter]

Those two pins on the underside of the rail.

 

[bdn6465]

If you tap the pins up into the rail, would they sit below the top rail surface? just in case you are putting the ring/mount in those spots...

 

[bdn6465]

Nevermind the question. I see the rail is thicker than the length of the pins, so it would be OK. But once you do that, would you be able to pull the pins back out?

 

[david walter]

Yes, there’s a hole in the top where the pins are that you can tap the pins back down

 

[Jefe's Dope]

How is this still available?

 

[david walter]

$600 with the three 308/6.5 Creedmoor/6mm Creedmoor CTR mags shipped or $475 without.

 

[Jefe's Dope]

Go list it on Ebay. There's a chassis only listed for $1200. You'll sell it for more and quickly, I assume. Your price is an incredible deal.

 

[roberthu526]

I assume this will fit all caliber from 223 to 338? Never built anything custom so want to make sure.

 

[roberthu526]

I will take it all. PM sent

 

[david walter]

Sold