Putting the finishing touches on my build. Only issue I’m having is that the magazine lips extend too far up and prevent the bolt from closing. If I release the magazine and hold it just a bit lower, I can cycle rounds through without any issues.
How do folks go about trimming magazine lips? Just flip it upside down on a piece of sandpaper and scrub ‘till it fits?
Build info
Action: ARC CDG LA
Barrel: 280AI take-off from a savage ultralight (proof carbon)
Chassis: Grayboe Eagle Pro
BM: greyboe M5 DBM CIP
magazine: MDT polymer 3rd LA 30-06
Triggertech primary
How do folks go about trimming magazine lips? Just flip it upside down on a piece of sandpaper and scrub ‘till it fits?
Build info
Action: ARC CDG LA
Barrel: 280AI take-off from a savage ultralight (proof carbon)
Chassis: Grayboe Eagle Pro
BM: greyboe M5 DBM CIP
magazine: MDT polymer 3rd LA 30-06
Triggertech primary
