Uni throater???

Baron85

Sergeant
Full Member
Minuteman
Mar 18, 2012
1,940
1,287
Has anyone used a uni throater?

I have a new proof 223 barrel that I want to extend the throat to get better performance with the 75 and 88 eldms. Wondering if this is easy enough to do myself or if I’m better off sending to a gunsmith?
 
Are there any other steps or tools needed or just ream it until you reach the length you want?

I will pull the barrel and mount in a barrel vice.

Do you use lube on the reamer or just dry?

Last? Where did you rent one?
 
Are there any other steps or tools needed or just ream it until you reach the length you want?

I will pull the barrel and mount in a barrel vice.

Do you use lube on the reamer or just dry?

Last? Where did you rent one?
I used oil or maybe wd40, then washed it out with brakeclean when checking it. I rented it from 4d reamer rental I think. It's made for doing it so it's pretty easy. There's a cutting reamer with a pilot then a stop that you can set per 1/1000". You know how far you are wanting to go I assume, so you can set the stop before that point then check it and go a bit more to get there and be done. It's pretty easy to do just be careful.