Does anyone have any experience with a Vudoo in the XLR Envy Chassis? I am looking for recommendations on what contour and length balances the best with adding the least amount of weight to the chassis. Kukri or MTU in 18” or 20”? I like a balance point right in front of the magwell.
Vudoo barrel in XLR Envy Pro
- Thread starter Jt2424
- Start date
I personally don't have an Envy, but I know that everyone else I run with has to have weights up front, so the heaviest barrel you can find is the best way to go to reduce the number of weights.
Oh I ended up with an Envy Pro. Remove the weights in the rear and the weights in the buffer tube. This is only running 1 pair of external weights up front. It's not too heavy, I think it was 15.7lbs w/o bipod.
Nope an 18" Kukri.
I'll have a 22" MTU on order soon. Then I think I'll end up dropping some of the internal weights. Also got the longer nose extension for mine to get another 6oz up front.
Primary Adaptive Solution Systems (PASS) Atlas Bipod Clamp-On Adapters
The Primary Adaptive Solution Systems Atlas clamp-on adapters attach to your Atlas BT10 or PSR bipod legs and allow the shooter the ability to run an additi...
www.altusshooting.com
Yeh they're the standard atlas rubber feet. Can swap it to the spiked, etc.
Not a mag extension, just a little color block to make it easier to grab and can tell the diff between my magazines. I don't like removing the little loader pull mechanism so I don't run any extensions. I have a 12 round aluminum mag for longer stages.
I sent my XLR Envy back to XLR to measure the Aluminum mag and do some inletting work to get it to fit. They wouldn't fit out of the box.
So if you're planning on running the Envy with Vudoo/Aluminum mags, I'd call them up and ask them to inlet the mag well to fit the alu mags.
So if you're planning on running the Envy with Vudoo/Aluminum mags, I'd call them up and ask them to inlet the mag well to fit the alu mags.
Sorry to bump an old thread, but I just received my Vudoo in an Envy Pro and am having the same issue. Could you PM me the same info about XLR fixing it? Tried to send a PM, but kept getting an error.
After XLR worked the Envy chassis to fit the aluminum Vudoo mags, have you experienced issues with the plastic 10-rounders?
Nope! I run both poly mags and alu mags about 50/50 in my matches depending on 10-round or 12-round stages, and shoot about 400 rounds a month. Haven't had any issues.
I wanted to chime in my experience.
No issues with the latest generation (thanks to @CSTactical ) of the XLR Envy JV Pro chassis using V22 aluminum magazines on a V360.
I will admit that any acting force on the magazine will cause feeding issues. However, that’s just the inherent nature of a chassis system lacking an adjustable magazine catch and the lack of fine-tuning capability on the Vudoo magazines.
No issues with the latest generation (thanks to @CSTactical ) of the XLR Envy JV Pro chassis using V22 aluminum magazines on a V360.
I will admit that any acting force on the magazine will cause feeding issues. However, that’s just the inherent nature of a chassis system lacking an adjustable magazine catch and the lack of fine-tuning capability on the Vudoo magazines.
