What ammo (initial order)?

[Trek]

I am having my first HP rifle built (20 inch 308, bolt gun)... And I would like to start ordering my initial supply (say 600 rounds), with the idea to re-load that brass going forward.

Question… What manufacturer should I choose?
1) Frank, in his videos recommends Prime… I did phone prime this afternoon and didn’t get an opportunity speak to the owner but it was suggested that they may have supply challenges… (and no Lapua brass)
2) Asym - I have had good results with their 9 mm rounds, and although they are more expensive, they do use Lapua brass (reloading potential)
3) Creedmoor or Wilson Combat - Similar price point, and they do use Ldpua brass which is a benefit

Any thoughts, or experiences and what path to take?

Thanks for the assistance!

 

[wade2big]

FGMM 175 grain is a great load that I am sure will shoot in your rifle. I can’t say how Federal brass holds up when reloading.

 

[Codiekfx400]

This is cheap and should be good quality. https://www.midwayusa.com/product/1...ester-165-grain-express-polymer-tip-box-of-20

 

[Trek]

Thanks Codie... That is a great price it’s a little fast 2700, and the brass is non-discript. I’m New to re-loading 308 and have no brass on hand… whatever factory load I purchased would be the building block for my reloading, hence my request for Lapua. AYSM or Creedmoor are the two leads. ?

 

[antithesis]

If you are looking to reload Lapua brass, why not buy Lapua ammo?

https://www.milehighshooting.com/lapua-4317515-308-167gr-scenar-50-box/

 

[Codiekfx400]

The Geco is more than likely the same brass quality as Norma. To be honest I have had good luck with most brands of brass except Nosler. For whatever reason the Nosler brass seems too hard and the necks crack on the first reload. And the Nosler is way overpriced imo.