What is needed to attach spigot to AICS

[LR-Shooter]

I recently acquired an Aics 2.0 and it came with an IMUNS without the circular hole to accept the spigot. I want to remove it but I am not sure what I need to purchase to put in its place that accepts the spigot, can you point me in the right direction? I don't have an atlas yet but am planning on getting one.

Thanks

 

[Roddd]

If you're removing the IMUNS, all you do with the spigot is plug it directly into the chassis. No tools required. You can sell the IMUNS to fund the bipod and spigot purchase.

 

[LR-Shooter]

If you're removing the IMUNS, all you do with the spigot is plug it directly into the chassis. No tools required. You can sell the IMUNS to fund the bipod and spigot purchase.

Once I remove the imuns there is a big square hole in the chassis. All the spigots I have seen have a round shaft that slides in the front of the chassis. I need that female piece that accepts the round shaft from the spigot.

 

[turboek]

I just installed an IMUNS in my chassis, Not sure if there's a difference in the LA to SA blocks but I'll sell mine. If your interested PM me.

 

[LR-Shooter]

I sent you a pm for info

 

[Raufoss]

You need the Female portion(square block) that goes in the stock.

 

[LR-Shooter]

You need the Female portion(square block) that goes in the stock.

Is it the hand stop (see below link), its the only thing I could find that has the hole.

AI-2510 Handstop / Bipod Mount

Thank you for your help!

 

[Okak]

This is a picture of the spigot block, sling mount bar, bipod mount and roll pin from an AICS 2.0. I think this is what you're looking for. If you don't work out a deal with turboek, you might try AI directly.

 

[LR-Shooter]

Thank you so much for that clarification. I will see if Turboek and I can make a deal. I dont have enough post yet to sell my IMUNS so I may go ebay route our something.

This is a pic of the one I have, I traded for this rifle from GaryinCC

http://www.snipershide.com/shooting...-308-6-5x284-switch-barrel-multicam-aics.html

Thanks!

 

[Roddd]

You can always run a Harris bipod and leave the IMUNS in place. I'm sorry I misunderstood your question originally. I don't know where you can get the female piece for the chassis, but it sounds like you may have a lead on one and I hope it pans out.

 

[LR-Shooter]

No worries, I appreciate the help. Turboek is hooking me up

 

[irishshooter]

I have contacted sporting services in the uk about these and they can order them from accuracy international

not cheap though!

 

[oklahoma_tc]

I absolutely hate that I have to be the one to resurrect this post... However, I am in the same spot. My AICS 1.5 does not have that piece either and I am on the hunt for one of those female pieces to insert the BT19 Atlas Spigot into. All help in finding one would be immensely appreciated! Also, if no luck on the female part, I’d be open to putting an IMUNS on instead of someone has one of those not in use.

Pic below shows the current mount. Current mount will be available for purchase if one of the above are found.