Hey guys,
I have some 6.5cm Hornady brass used to break in my Stag10. While adjusting my gas block I chew up some of the brass a little bit.
These are the photos of the worst of it. I’m wondering (as a new reloader) when is a dent too bad to reload?
There are also some “scratches” on the neck of all rounds fired, as seen in photo.
Could I, SHOULD I reload this brass?
I have some 6.5cm Hornady brass used to break in my Stag10. While adjusting my gas block I chew up some of the brass a little bit.
These are the photos of the worst of it. I’m wondering (as a new reloader) when is a dent too bad to reload?
There are also some “scratches” on the neck of all rounds fired, as seen in photo.
Could I, SHOULD I reload this brass?