Gunsmithing wolff spring kit

[1shot2kill]

i purchased a full replacement kit for my beretta 92fs and i was able to get 4 out of 7 taken care of but i still have 3 small coil springs left and im not to sure where they go and i cant find good info anywhere on a full teardown any info would help

 

[andyjason]

Re: wolff spring kit

try this link.

http://www.gunpartscorp.com/catalog/Products.aspx?catid=9299

 

[BHP9]

Re: wolff spring kit

probably for the safety.

 

[wareagle700]

Re: wolff spring kit

I installed that pack in my M9 along with the steel guide rod.
Here are some videos that may help.

http://www.beretta92fs.com/

 

[1shot2kill]

Re: wolff spring kit

thanks for the feedback i am down to the firing pin spring but not really sure how to get it out

 

[wareagle700]

Re: wolff spring kit

You have to remove the the thumb safety on the slide. Use a 1/16 punch to tap out the pins located on the right side. The safety should be on when you tap the pins out so they come out through the bottom of the slide.

 

[1shot2kill]

Re: wolff spring kit

i am going to wait to replace the firing pin spring until i have a new firing pin