Reloading Equipment WTB/ WTT towards small pistol Primers or Dillon 750 near Billings,MT

[4066.5]

Getting out of reloading for my rifles and swapping over to pistol reloading at the worst possible time.

My ideal set up would be dillon xl750/9mm conversion kit with case feeder, federal gold primers, 147, 135 or 125 blue bullets, and starline brass... But that's a long shot.

Willing to pay cash but also have to follow to trade if any interests you

-impact action w/ proof comp contour in 6.5cm with a hellfire brake, tt diamond, MPA BA chassis.. barrel is at end of life with 1600 rounds through it and opening up a bit. (Trade valued at 2k)
-223/6.5CM curtis custom with WTO S/L mpa chassis, tt special trigger, both barrels are low round count. (Trade valued at 2300)
-inline fab mount for COAX
-redding 6.5cm, 300wm, 223 redding dies but none have decapping or expanding with them
-sinclair expanding mandrel and die for the above calibers
-redding universal decapping die
-little crow WTF for above calibers, all are like new.
-winchester white box 9mm , I'll only trade that towards primers.
-cash

Easiest way would be if you were within or meet within 4 hours of Billings,MT.

Thanks.

 

[rg1911]

In the unlikely event that you get somewhere closer to Laramie, WY, hit me up for pistol primers.

BTW, on one of the Dillon equipment forums, I read a few reports of primer feed problems with the new 750. I suspect this is a minority, but it means I'll stick with my 650 until Dillon comes up with a fix or better instructions.

Cheers,
Richard