If you could only have one bipod for PRS and NRL Hunter what would it be? Particularly interested in the CKYE-Pod line.
Which bipod for PRS and NRL Hunter
- Thread starter Billygoat934
- Start date
If you’re using just one for both matches, the double pull. The triple IMO is too wide for PRS work. That is just a personal opinion. For NRL, triple as mentioned above. It does weigh a lot so keep that in mind when doing your NRL build if you have specific weight goals.
I’ve used a triple pull in PRS matches many times. Used it all of the 2021 season pretty much exclusively. That said there were definitely times I wanted something slimmer. You could always ask to borrow someone’s bipod for a stage where a triple doesn’t work.
I’ve also shot NRLH with a double.
So either a triple or a double if I could only have one.
I’ve also shot NRLH with a double.
So either a triple or a double if I could only have one.
Check out the Gunwerks Elevate 2.0. Very similar to the double pull, saves some weight and money.
Standard single pull Ckye pod.
In PRS if you need a double or triple pull someone in the squad will have one. (Most of the time, even when the whole squad thinks they need it.. you don't need it).
If you need more height in NRL Hunter, use a tripod with a tac table. It's usually set up to glass off of anyway.
In PRS if you need a double or triple pull someone in the squad will have one. (Most of the time, even when the whole squad thinks they need it.. you don't need it).
If you need more height in NRL Hunter, use a tripod with a tac table. It's usually set up to glass off of anyway.
Double pull lightweight. I run one for NRL hunter and also carry the same bipod in my PRS pack. My default PRS bipod is the Atlas CAL but I could easily run the double pull without complaints.
Side note - I did drill and pin the double pull to remove any panning rotation.
Side note - I did drill and pin the double pull to remove any panning rotation.
How does the ARCA clamp hold up under recoil? Specifically does it slide on the rail? I’ve been using the RRS SC-ARC Bipod clamp on my Atlas bipod and I really like how when used in conjunction with the RRS rail it locks into place eliminating any slide on the rail. I had thought about using this clamp on one of the CKYE pods but looking at pictures online it looks like you can’t swap out the bipod clamp on the double pull lightweight?
I’ve had my bipod pop off of the arca rail when shooting off a bag or tripod with a heavy recoiling rifle. Never while shooting prone with it. It does work itself loose, but if you tighten it good and check it every so often, it’s a non issue
I don't have a ton of rounds through it, but thus far it hasn't fallen off. I shot a NRL Hunter match last weekend with a lightweight 6.5 creed and it held fine across 19 stages in one day. There's probably some movement under recoil but nothing that's caused an issue.
Ran mine through a K&M precision rifle class. Torqued it once hand tight and never touched it for the rest of the two day class. It stayed where I put it.
There IS some wear on the inside of the clamp but i'm not sure what exactly is causing that. I don't generally reposition the clamp so it's probably not from sliding the bipod fore or aft. This is a single pull CYKE Pod so it's not the heavier variants.
Mine on my 30 Sherman Mag moves. need to keep an eye on it, my buddy had his come off his 300 Norma while on the clock.
I run either RRS or area419 acro clamps on all of mine, never had an issue with them jumping the rail.
