Optics mount issues

[slyver11]

I have a 737r and use a area 419 tac mount 34mm tube 39mm hight 20moa. My issue is that the cases hit the Pic rail mounting points and fall strait down sometimes back into the ejection port. I tried moving it in every possible position and still have issues. The action ejects fine when the mount is removed. I am waiting to hear back from area 419 and impact to hear what they say. I don't want to use rings and the mount needs to be tall enough for the scope to clear the mdt elite bridges I'm waiting on. Anyone that has experience with the impact 737r and is using a mount that fits my parameters with no issue please let me know. If it matters I am shooting 6mm dasher with grey ops aw mags.

 

[Southpaw357]

I’ll have to check my impact action to compare later but that video with no mount shows the case flicking upward, which is driving it into the mount. Reminds me of the old stillers. Wish i could be more helpful.

 

[slyver11]

The more I look into it I think it might be my extractor.

 

[Southpaw357]

The more I look into it I think it might be my extractor.

Extractor or Ejector

 

[slyver11]

This is my first bolt action so I don't really have experience to go by. But I have had gas guns that had extractors that held the rim to tight and flung the case in weird directions. I am not 100% that is what's going on here. That's why I posted. I appreciate your time, thanks

 

[Scott Parks]

It sure looks like the mounts rear clamp is impeding the ejection port. The relief cut on the under side of the Pic rail is there to allow clearance for ejection.

If you absolutely need to have your mount that far forward I would try mounting your scope with the clamps on the opposite side of the action. Make sense?

 

[TahoeDust]

Just curious, is there any particular reason you don't want to run rings? They would probably solve your issue. I love my mounts on ARs, but definitely prefer rings on my bolt guns.

 

[slyver11]

I switch the scope between rifles sometimes and like the return to zero of the one piece mounts. I have been noticing that upon ejection without a mount that the cases slam into the back of the ejection port like a ar 15s deflector. I have been watching videos of other 737r's and they don't contact the edges of the port. It's dinging up the mouths of my brass.

 

[slyver11]

Placement on my action makes no diff, it's the same outcome. I have more vids if you want to see them I just didn't want to take the time to post them.