Fastened 2-round Quill for MDT ACC

[envitro99]

Hi,

does anyone know of a 2-round holder/quill that can be fastened to the MDT ACC chassis holes that are just ahead and below the action?
Not sure I want to go down the velcro route, like the SAP, which I'm sure is fantastic. Just a preference of mine.

Thanks!

 

[0724/1030]

Hoptic - remove the backing to the m-lok and bolt straight on.

https://www.hopticusa.com/product-page/quiver-308-similar-m-lok-keymod-picatinny

 

[envitro99]

Thanks! Ended up ordering the Hoptic MLok after getting confirmation from Matt at Hoptic and Ryan from MDT!

Thanks again all.

 

[anotherwannabe]

@envitro99 Sny pics of your ACC with the hoptics installed? It looks like it would block the ejection port a bit to me based on height.

anyone else have other options or even pics of where they are putting the standard velcro SAP one? there isn’t an obviously good location for it that gets full contact with the chassis.

 

[Skunkworx]

@envitro99 Sny pics of your ACC with the hoptics installed? It looks like it would block the ejection port a bit to me based on height.

anyone else have other options or even pics of where they are putting the standard velcro SAP one? there isn’t an obviously good location for it that gets full contact with the chassis.

 

[anotherwannabe]

Thanks! Not sure I love how high that is near the port

 

[Skunkworx]

Thanks! Not sure I love how high that is near the port

You can move it over to the most rearward mlok slot if desired

 

[anotherwannabe]

Then its right where I grab the rifle when moving between positions and what not, which is even less good. I might be sewing up some single velcro holders and sticking them above the mag on the two diff surfaces above the mag.

 

[MDT_Josh]

I have been shooting with a Hoptic M-Lok Quiver on both of my match guns all season and haven't had any ejection issues, even with live rounds By the time the tip of the round/brass has cleared the port, it is typically above where the quiver is mounted.

Josh

 

[anotherwannabe]

At shot shot you guys are going to co-announce the 7mm offset south version of the quiver right? ?