It’s not quick, but I like using a Wilson trimmer with case holder. Plus I can use the set-up to inside neck ream or ream primer pockets. I don’t trim hundreds at a time, more like 50, so it works for me.
I use a squirt of 3-n-1 oil on a gloved hand and then stir my brass around in a 1 gallon storage bag. Slickest lube I’ve ever used, absolutely zero drag when sizing and cleans up in an ultrasonic cleaner.
I also used a PP uniformer to clean up the pockets. First used straightens the PP walls...
I bought the LabRadar LX recently and got it out to the range last week. It worked great going back and forth between a 6 creed and a 7-300 NMI. It didn’t pick up any other shooters at nearby tables and worked with the unsurpassed creed and suppressed NMI. No connectivity issues with the...
Well, I resisted as long as I could, but I finally picked up a SOLUS obsidian with mag bolt face from Classic Firearms, the price was too good. Then I went to the Aero website and purchased a .478 bolt head and action wrench, both on sale.
I think I’ll make this one a 22 or 25 creedmoor…
For the cost of a surgeon, I would buy an impact. I have 3, a 737 and two 787s, by far my favorite action so far. I also have the original Bighorn sporter, surgeon 1086, APR G2, Terminus Zeus QC, and a Kelbly Atlas.
A little off topic, but I have a Zeus QC and was thinking of buying an extra bolt with Lapua bolt face for a future 300NM barrel, that’s not recommended by Terminus?
Keith at PCR was sketchy about the short amount of threads on the tenon when he chambered my 300WM.
@rlsmith1 any concerns with...
So if I’m reading this right, the chamber stops where the case neck ends, and then a taper is cut at an angle until you reach a point a distance down the barrel where the bullet will eventually engage the lands?
This is probably a stupid question, but I googled and didn’t find a glaring answer that slapped me in the face…
I had a pre-fit in 30-06 spun up for me. The data sheet that came with the barrel said the freebore was 0 and the throat was .221.
Does that mean the reamer had zero freebore, and...