Recent content by VURTLE
-
V
16-18 inch shorty rifles
I believe the stock has enough room for a heavy varmint. Not positive though. Mine has a ton of room around the sporter barrel. The stock has the aluminum block in it. It required a longer front action screw. I like it. It is heavy though. Probably not heavy compared to a lot of rifles on this...- VURTLE
- Post #704
- Forum: Bolt Action Rifles
-
V
Looking for a pic of a Rem 700 Sporter barrel in a Varmint stock channel
I run a short sporter barrel in a bobby hart stock that has plenty of room around it. It looks good and gets a lot of compliments.- VURTLE
- Post #6
- Forum: Bolt Action Rifles
-
V
16-18 inch shorty rifles
Rem 700 243 win - stock barrel cut to 18 Bobby Hart stock with aluminum block Timney trigger New remage barrel to come in a few months. For me the short barrel carries well, but my rifle jumps a lot and hard to watch impacts. A muzzle brake is a must for me.- VURTLE
- Post #700
- Forum: Bolt Action Rifles
-
V
Gunsmithing Bolt closing hard new rifle
Yea, I forgot it was belted, but still the same as far as the shoulder goes. I try to stay away from belted cartridges. Nothing wrong with em, just never viewed them as necessary or appealing.- VURTLE
- Post #6
- Forum: The Armory
-
V
Gunsmithing Bolt closing hard new rifle
Like RidgeRunner said, Check your headspace. You may have a tight chamber. If you know anyone who reloads your cartridge, have them slowly push the shoulder of a once fired brass back in small increments until the bolt closes with ease. Or have him pull a bullet from an unfired round that is...- VURTLE
- Post #4
- Forum: The Armory
