-
Having trouble using the site?
Post any issues in the thread below or reach out directly to support!
Contact support
25x47 Lapua load data
- Thread starter JMGlasgow
- Start date
I'd start at 32.0 grains add half grain increments working up to the mid 2600's, then load 150 of them knowing that somewhere around 100-150rnds in you will likely gain velocity and what shot good before that may not shoot as good after the change. Some folks I know have been OOHing and AAHing about the mid to low 2700's but they are using N150.
Does seem like you'd be pushing it a bit to meet PF. I was considering a 6.5x47 tube with the idea of shooting 144s to help reach PF without running too warm in a 24-25" barrel.
From reading all these replies, I just want to confirm that the tools required (seating and sizing dies in particular) are both the same for 6.4x47 and the 25x47. So theoretically someone could build a gun in each and have everything they need as long as they had the appropriate bushing/expanding mandrel
I wish I hadn’t asked. Part of me really wants to turn my 6.5creedmoor into 6.5x47 when I need a new barrel and then build out the 25x47 ha
Looking for some recommendations on starting powder weights for the following:
25x47 Lapua, 24" barrel, 1:7.5 twist
135gr Berger LRHT
H4350
I'm looking to get around 2800fps.
Looking at previous posts, what I found was around 39.0gr H4350.
I'd appreciate any input. Thanks.
25x47 Lapua, 24" barrel, 1:7.5 twist
135gr Berger LRHT
H4350
I'm looking to get around 2800fps.
Looking at previous posts, what I found was around 39.0gr H4350.
I'd appreciate any input. Thanks.
