Mag well and butt are affixed and hardening. Since this is not a production unit I'm not taking the time to let each stage properly cure. It was a ton easier to affix them to the base chassis than it was to fabricate the bits themselves. Sometime later today I'll pull the rifle action from the chassis. I set the mag well up with the action in the stock to make sure I got all the angles of dangles right and zero'd out any slop: I insist that feeding from the mag be 100% right out of the box even if that means mags are a little snug fitting in the mag well. The rear of the action is retained, for now, in the stock by a hoop and the front is retained by the safety selector. I'll drill the holes for the cross bolts later but it's nice to see that it could be a tool-less arrangement if I wanted to. I have a good bit more FG work to do to finish the fencing around the mag release hardware and to set up the bag rider / spare mag well and getting the pistol grip boss affixed and reinforced but it's darned near ready for void filling and truing and then I can make a proper mold and then I can produce the final version. One thing I can say, even with the quick and dirty nature of this effort, it's one rigid little bastard.