spr

  1. theke

    FN SPR in 300wsm, opinions?

    Is any one using an FN SPR 300wsm? Optics? Mounts? How does it perform. What loads does it like best? Thanks, CLW
  2. C

    Photos FN SPR with some stencil work.

    These are some pictures of my FN SPR A2 after a recent paint job and some custom stencils i made. I found a way to use contact paper and a laser engraver to cut precision stencils that would be next to impossible by hand.
  3. T

    Gunsmithing Bottom Metal for my FN SPR M40A5

    Hey gentlemen, I am wondering if any of you have had any experience with the CDI precision bottom metal for their rifle, but in particular the FN SPR rifles. I have one and am looking real hard at installing this system, it already takes the FN detachable mags, but they only hold four rounds. If...
  4. Txmxracer

    Gunsmithing FN SPR CDI bottom metal

    Is the installation of this bottom metal a do it youself project or does it need to go to a gunsmith. Will I need to have it bedded at the same time? Thanks for the help guys. shane
  5. K

    what is an fn spr a3g w/nightforce 5.5-22x50 worth

    maybe someone can help me out , fn spr a3g /nightforce 5.5-22x50 nsx with mlr reticle and nightforce rings , jewel trigger , hardig storm case w/ cut to fit foam. what is this worth ?
  6. S

    fn spr action

    any thoughts on a rifle build with this receiver?thanks
  7. S

    Gunsmithing fn spr action

    any thoughts on this receiver for a build?thanks
  8. O

    Gunsmithing FN SPR bottom metal - Hinged/DBM interchangable?

    Anyone know if the hinged floorplate and the DBM bottom metal are interchangable? I found a mcmillan inletted for DBM and I have a hinged floorplate. Will it work?
    • operator1
    • Thread
    • bottom hinged or dbm interchangable metal spr
    • Replies: 7
    • Forum: The Armory
  9. P

    Photos Suppressed FN SPR

    Just a few photo's of my FN SPRA1. Recently got it threaded fro my .30cal can. I did have it in it's original A3 stock, but switched it out to an A4 with a hinged floor plate. Also had it pillar bedded. Enjoy the photos http://s156.photobucket.com/albums/t36/1505scouts/Gun%20Collection/
  10. corrigidor

    Range Report Best factory 77gr SMK for a SPR

    Any opinions-- FGMM out of my Noveske 18" is only clocking at 2500ft/sec. Without having to roll my own.. is there anyone else making hotter 77gr match load (MK262 stuff aside)? Corbon perhaps? Core
  11. V

    .308 hand load for FN SPR

    I have been hand loading for a .308 FN SPR 1:12 twist.The load I'm using is once fired Lapua brass,168 gr. Hornady A-Max bullet,46 grains of Varget and CCI BR primers.I don't think the bullet is stabilizing through the air because the hole that it's creating is slightly large looking compared to...
Top Bottom
Back
Home
Forums
Merch
Alerts