varmint

  1. malaga2

    CZ452 Varmint

    Finally think that Ive got this rifle set up the way I want it... Gemtech Outback II suppressor and US Optic ST10 glass. Absolutely the dogs bollocks
  2. 2brothers641

    SPS Varmint .204

    I just got one of these on trade. I need some advice on future upgrades. First off the trigger pull is awfull to say the least. Can you get the x mark to perform or should it just be replaced? Next is the stock. What is a good up grade with full length aluminum bedding that wont break the...
  3. Dsparil

    Gunsmithing Choate Ultimate Varmint and Badger DBM

    is it possible to drill out the trigger guard and install the badger ordnance DBM? I saw one of the rifles at one of zak smith's shoot had a detachable magazine system on it. thanks.
    • Dsparil
    • Thread
    • badger choate dbm ultimate varmint
    • Replies: 8
    • Forum: The Armory
  4. M

    .243 twist ? Rem SPS Varmint

    I'm pondering the Remington SPS Varmint in a .243, which comes with a 26" 9 1/8" twist barrel. It seems like 1-8 is the way to go, but would the Rem factory barrel likely be O.K. with the 105/107gr range of bullets? Down the road I could always have a new barrel put on, but I'm thinking of the...
  5. 96C

    Gunsmithing Badger FTE for Remington Varmint Barrel Contour

    Hi fellas, I need a bit of help with this as I'm overseas again and have no access to my rifle for measuring. My Remington 700 SPS Tactical has a 20" Varmint factory barrel. Badger Ordnance makes their FTE Brake in two sizes: 3/4-28 for minimum .875" 5/8-24 for minimum .800" <span...
    • 96C
    • Thread
    • badger barrel contour fte remington varmint
    • Replies: 2
    • Forum: The Armory
  6. Sniper1*

    Advanced Marksmanship RRA A4 Varmint POA/POI Changes

    OK, In a nutshell! I am shooting a RRA A4 Varmint 18"(as it came from Factory). Magpul PRS Stock USO 1.8x10 Tpal Nightforce Unimount Harris Bipod Hornady 55gr TAP After zeroing the rifle and scope I would return to the range on several occasions and the CB and subsequent 5-8 shots would be...
  7. S

    SPS 300WSM Varmint

    Have one sitting here about to be sent to the smith to fit up a #7 Broughton. I'm scared to shoot it because if it shoots well I will prob put the build on hold. This wouldn't be a bad idea because I need to move up in scopes instead of building another rifle. Question is are any of you guys...
  8. C

    CZ 452 varmint CZ 453 Varmint

    Anyone know the difference between these two? I checked out the CZ site and really couldn't see one. There must be something because I priced the 452 out at $400 and the 453 at $500.
  9. K

    Advice need on a stock for CZ 452 Varmint

    I need advise on a new stock for CZ 452 Varmint, in the best case scenario wanted to set it up in McM HTG stock and was wondering if anyone done or if McM inlets that stock for that action. If anyone have done it or pictures would be great.
  10. skatz11

    Best Stock for CZ 452 Varmint

    I want to build a nice trainer rifle starting with a CZ 542 Varmint. Anyone have any experience putting something like this together? I'm trying to match this as close to my FN SPR as possible. I haven't ruled out McMillan due to cost, but but its more of a last resort. Does anyone have an...
  11. C

    .308 Varmint Loads

    I was just inquiring if any of you have used your .308 for some varmint hunting. I was looking at the 125grn Speer TNT's and I was thinking that my LTR would make a nice walking varmint rifle I was just wondering if any of you have good success with the 110grns - 125grns. I have my own...
  12. Steelhead

    Range Report RRA LAR-8 Varmint and Mid-length

    I was able to get out and shoot the LAR-8 Varmint and mid-length today. I just goofed around with the mid-length and just shot surplus through it. I had purchased a Trijicon 3.5x ACOG scope with .308 ballistic reticle, so I got it all sighted in and then proceeder to have a great time banging...
  13. N

    CZ 550 Varmint .308?

    Does anyone have any experiance with these rifles? how does it shoot and what are the pros and cons?
  14. R

    Is an 18" varmint barrel too heavy on an AR?

    I'm thinking of getting an AR with an 18" varmint barrel. The AR I used to have had a 16" hbar. I tend to like a little heavier profile. I just wanted to ask folks who own something similar is it too heavy to shoot off-hand for plinking? I'm not going to be kicking down any doors or anything...
  15. P

    Rifle Scopes Weaver V-series scopes? Tasco Varmint? Buckmaster?

    How do the Weaver V-series compare to the Nikon Buckmasters and Super Sniper series? I know the SS are fixed power but I am asking about optical quality and really overall quality. There are a lot of us who can't buy a NF, USO, S&B or other top-end scope. We end up aggravating some people by...
  16. 0

    Rifle Scopes Tasco Varmint 2.5-10x42 (internal adjustment)

    Looking at putting a Tasco varmint 2.5-10x42 mildot on a 22lr rifle until I have the funds to put a Buckmaster on it. Does anybody know the amount of internal travel the tasco has? Any other cheap scopes you would recommend to put on the rifle until I have the Buckmaster? Would like mildots...
  17. P

    Tikka T3 Super Varmint vs T3 Tactical

    Other than a threaded muzzle, what is the real difference here? Looks like they use the same stock, same pic rail, maybe a slightly different barrel...would I be paying for just Tacticoolness or is it a real upgrade? Also, who has these things in stock? Thanks!!!
  18. O

    CZ550 Varmint .308-20 MOA rail mounting.

    My neighbor came over Sunday with a brand new CZ 550 and a 20 MOA rail from US Optics. I am not familiar with these rifles at all, fact is this was the first time that I've got my hands on one. It has a dove tail action similar to a Sako. I need some input on mounting this rail. Is it necessary...
  19. slayer_21420

    winchester model 70 heavy varmint?

    just picked one of these up in 243win for $350, I haven't shot it yet, it has less than 100rds through it. I was wondering if any of you guys have experience with this rifle, and what twist they are? thanks, Steve
  20. LSUbeatUby40

    Anyone knowthe OD of an H&R Ultra Varmint?

    Rifle? I hav a 762-SD I want to be able to mount on it and I don't know the OD of the barrel to know if I have to buy a new 1/2x28 18-tooth blackout mount or if I can use the 9/16x24L one I already have..
Top Bottom
Back
Home
Forums
Merch
Alerts