11mm to Weaver

[clayne_b]

I have a CZ 452 Scout

Ok i have done some looking and searching and i need some of yall's thoughts and input.

I am aware of the J&P, from what i gather the are made to be used with the Burris Signature Zee Rings.

the question i have is what is the lowest, and would work best with this. I have one on the way and would like to have everything in order to mount it up when it gets here.

Link Below

http://vgmount.com/

Thank you for any input

 

[NYCEGUY01]

Re: 11mm to Weaver

The B Squares are the lowest.
A DIP rail might be the best setup for that...

Maybe the Weaver T-20 ? Its a weaver rail and its super thin. I just dont like how its not cut out for the action and looks like it may interfer with ejection on some rifles...

 

[clayne_b]

Re: 11mm to Weaver

I went with this

https://www.jnpgunsprings.com/product_info.php?cPath=10&products_id=236

 

[clayne_b]

Re: 11mm to Weaver

Well the J&P's didn't work, could not get it tight enough to not move easily. I went with the extended from DIP it should be here tomorrow

 

[condor22]

Re: 11mm to Weaver

EGW makes a 11mm or 3/8in Picatinny rail, 20moa canted or not. IT's abit higher than the DIP Weaver rail. Just use extra low picatinny scope rings, a plenty of 'em available. You will need the clearance for the bolt handle. I don't like the DIP vertical set screws chewing into the receiver. Most recommend putting a lead shot pellet under the set screws for the DIP Weaver rai1. The EGW Picatinny rail clamps to the 11mm rail just like any other 11mm rail accessory.

http://www.egwguns.com/other-scope-mounts/hd-cz-452-picatinny-rail-scope-mount/

http://www.opticsplanet.net/evolution-gun-works-hd-cz-452-picatinny-rail-scope-mount.html

Sam

 

[clayne_b]

Re: 11mm to Weaver

Thank you, That is one good looking gun!!!

I looked at all the options i could find, and being that i am using a variable gantry mount i with with dip because it is the lowest i could find.

I will try that with the lead shot.

 

[condor22]

Re: 11mm to Weaver

You won't be disappointed, DiP makes high quality products and also has good customer service.

Sam

 

[19Scout77]

Re: 11mm to Weaver

Might want to give an AI dovetail scope mount a try. Should fit an 11mm dovetail on a CZ.

 

[clayne_b]

Re: 11mm to Weaver

WAHOO it came today!

fit and finish look really good

 

[condor22]

Re: 11mm to Weaver

Looking good, time to mount your scope. Your rail is lower than mine.


Sam