I am new to reloading, I have been researching, reading, etc for a few months before I started. I am working on some 1x fired cases out of my RRA LAR-8. I noticed a small dent around the neck of the case, some of the cases had a small marking on them before I sized them but it seems as I did more it got worst. Here is a picture, but its kind of hard to see.
I am using a RCBS Rock Chucker press with RCBS FL .308 dies. I only did about 25 cases tonight and at least half of them have these marks with some being worse than others. They are Remington brass if it matters. Any help is appreciated as I am not sure these are safe to continue reloading with the "dents" in them.
I am using a RCBS Rock Chucker press with RCBS FL .308 dies. I only did about 25 cases tonight and at least half of them have these marks with some being worse than others. They are Remington brass if it matters. Any help is appreciated as I am not sure these are safe to continue reloading with the "dents" in them.