I am an experienced reloader, but new to 6.5CM.
I have some once fired Lapua brass getting light rings about .25" up from the case head. I did the hook test inside case with nothing I can feel.
I have neck sized the cases so hopefully not over working the brass.
!47 eld is loaded mag length (accurate mag with binder) so nowhere close to lands
Load is IMR 4350 at 41.0 gr with Fed match small rifle primers
Redding deluxe dies
Weather is 85 F of so with 80%+ RH (this is summer in NW FL after all)
Remington 700, More Precision chassis, 24" bbl 1:8,
Hopefully, I have given all the needed info.
Thanks,
Any ideas?
I have some once fired Lapua brass getting light rings about .25" up from the case head. I did the hook test inside case with nothing I can feel.
I have neck sized the cases so hopefully not over working the brass.
!47 eld is loaded mag length (accurate mag with binder) so nowhere close to lands
Load is IMR 4350 at 41.0 gr with Fed match small rifle primers
Redding deluxe dies
Weather is 85 F of so with 80%+ RH (this is summer in NW FL after all)
Remington 700, More Precision chassis, 24" bbl 1:8,
Hopefully, I have given all the needed info.
Thanks,
Any ideas?