6.8 SPC Brass: Rem or SSA?

[stealth_man]

..........

 

[EWP]

Re: 6.8 SPC Brass: Rem or SSA?

The SSA stuff is better than Rem, not only is it tougher and has thicker necks but the small primers provide lower ES & SD alone with better accuracy in most cases, the Hornady brass cost a bit more but is the best brass as far as consistency goes.

 

[VarmitSpecial]

Re: 6.8 SPC Brass: Rem or SSA?

I prefer SSA brass over Remington but havent had a problem with either. If you are patient enough you can usually get once fired brass at a good price.

 

[Sledge1]

Re: 6.8 SPC Brass: Rem or SSA?

I haven't tried the Rem or Hornady stuff, just the SSA. I've been told the Hornady has less volume than the SSA. I like the small pocket on the SSA also. I have reloaded the same 50 pcs of SSA 6 times and the pockets are still nice and snug. I load pretty hot too in my 6woa.

 

[felderthewelder]

Re: 6.8 SPC Brass: Rem or SSA?

Ssa all the way. If you buy it off their site it is cheaper than remington off midway. And it is way better, that is all I use in my Noveske.

 

[JTZshooters]

Re: 6.8 SPC Brass: Rem or SSA?

I use SSA then Hornady then S&B then if worse comes too worse my Remington large primer brass .

 

[hrt4me]

Re: 6.8 SPC Brass: Rem or SSA?

I use both SSA (small primers) and Rem (large primers)

 

[winxp_man]

Re: 6.8 SPC Brass: Rem or SSA?

Hornady is what I use.

 

[fred3]

Re: 6.8 SPC Brass: Rem or SSA?

ssa better case life