6BR Dies

To me, doing that you lose all of the reasons to get it. For me, this die decaps, sizes, and mandrels all in 1 pull. I long ago stopped decapping prior to tumbling. I dont see any affect on accuracy from my dirty pockets.

Im lazy so I want to find the most efficient and fewest steps to produce accurate loads. This set up I only run through my press 1 time.
 
Whidden full length resize die. With expander ball removed. Then the LE Wilson expander mandrel die. Then the whidden micrometer seating die.

This is pretty much the direction I ended up going.

I got a Whidden non bushing 6BR die (sent them 3 pieces of fired brass) and run it with no expander, then size the neck with a Wilson expander (double check neck tension with pin gauges).

Seating is with an SAC seater.
 
Last edited: