6gt comparator gauge

[Jab1134]

Probably talked about on here but it’s no where in google so I ask with hoping for a straight answer . What hornady comparator gauge for 6gt

 

[rijndael]

.375"

 

[Supersubes]

It doesnt matter. .375, .400. Its a comparator after all. As long as its not touching the radius at the neck shoulder, or going over the shoulder. I use a 400 for that sized case.

 

[Jab1134]

Thank you exactly what I was looking for

 

[Feniks Technologies]

Just an FYI for future stuff. If your comparators are basically datum gauges (just holes cut and not shoulder angle/cartridge specific) you can look at reamer print and see the recommended gauge.

As mentioned above, you can use others as long as it’s just comparing with your own brass.

 

[Jab1134]

Just an FYI for future stuff. If your comparators are basically datum gauges (just holes cut and not shoulder angle/cartridge specific) you can look at reamer print and see the recommended gauge.

As mentioned above, you can use others as long as it’s just comparing with your own brass.

That makes sense thank you