BRX. Fire forming loads are usually stupid accurate, you're running right up with a dasher, and no finding dies as 6br dies are everywhere.
Bob Crone who is credited with creating the 6BRX won competitions with his BRX fireforming loads.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
BRX. Fire forming loads are usually stupid accurate, you're running right up with a dasher, and no finding dies as 6br dies are everywhere.
Now I’m on the hunt for the Norma to trim down, turns out the alpha has some issues after the first firing.
I’ve had some fun ones so far and I’ve only going into the third firing on the brass. I’ve had pressure signs on the case head at relatively low pressure nodes, cratered primers (cci450) at lower nodes, weird bullet slip after the first firing causing me to get a tighter bushing then recommend by alpha. I’ve talked to the guys at alpha pretty extensively, sent them all the measurements off my brass to compare it against their standards for case dimensions and everything is with in spec except the slightly thinner neck.What issues are you having?
Pretty much, but it seated like it had proper tension and then I’d be able to push the bullet until it contacted powder and then be able to pull the bullet by finger till it hit the tight spot. In a few cases I was able to pull the bullet out of the case completely with just my fingers.What is weird bullet slip?
Lack of neck tension?
What powder are you using?I’ve had some fun ones so far and I’ve only going into the third firing on the brass. I’ve had pressure signs on the case head at relatively low pressure nodes, cratered primers (cci450) at lower nodes, weird bullet slip after the first firing causing me to get a tighter bushing then recommend by alpha. I’ve talked to the guys at alpha pretty extensively, sent them all the measurements off my brass to compare it against their standards for case dimensions and everything is with in spec except the slightly thinner neck.
I figured I’d save time and money with factory brass offering, but it seems I’ve spent more time and money trying to diagnose the weird stuff then it’s been worth. I like Alpha’s products but I’ve got a slight sour taste in my mouth now from this, and I’m shocked my “shitty” federal brass I’ve used/abused in my 6creed is holding up stellar.
When from a .267 down to .266What bushing?
VargetWhat powder are you using?
Varget is known to have some pressure spiking issues in the dasher. Try running rl16 or h4350. You wont be able to hit pressure with either of those but i found they worked way more consistently in my dashers running lapua brass.When from a .267 down to .266
Varget
I got one firing before it happened, but that might have just been a fluke with my brass.I find this with the Norma brass as well. It thins out and needs to be annealed, trimmed and sized one smaller. That’s not unique to Alpha. I get about 3 firing before I start getting inconsistent neck tension.
I thought about trying H4350 since I run that in my 6cheatmoor and would streamline some stuff.Varget is known to have some pressure spiking issues in the dasher. Try running rl16 or h4350. You wont be able to hit pressure with either of those but i found they worked way more consistently in my dashers running lapua brass.